Inputs Audio, Ext Clock (CV), Cutoff (CV), Resonance (CV), Seq Reset (CV)
Outputs Hi Pass (Audio), Band Pass (Audio), Lo Pass (Audio), Sequencer (CV), Sensor (CV)
Rear Panel CV Controls Sensor Out, Resonance In, Cutoff In, Sequencer Out
Controls Seq Speed, Seq Length, Seq Steps, Input Gain, Cutoff, Resonance
Casing Powder coated aluminium casing, silk screened text and wooden side panels
Dimensions 23 cm x 15 cm x 5 cm (L x W x H) / 9″ x 6″ x 2″ (L x W x H)
Net Weight 850 gr / 1.8 lb
Shipping Weight 1 kg. / 3.0 lb including power adapter and instruction manual
Power Requirements 9V DC power adapter, 500mA min, center polarity negative (only use the KOMA adapter shipped with the pedal)

Out of stock


The FT201 Analog Filter / 10-Step Sequencer is our innovative voltage controlled vactrol state variable filter combined with a 10 step sequencer. The FT201 is capable of providing ultra low and high frequency filter effects which are controllable with the on board infrared expression controller, which allows the user to create filter sweeps by moving their feet or hands over the pedal. The FT201 has 3 different filter outputs: band pass, low pass and high pass, which all work simultaneously and are accessible as outputs on the patch bay. The cutoff frequency range is very large, between 20 Hz and 20 kHz and because of the vactrols used the sound quality is superb. The 10 Step Sequencer runs through the selected amount of steps (2 – 10 steps) and adds the control voltage to the value set by the Cutoff knob, thus modulating the cutoff frequency in every step.

On 13 Dec 2017 the FT201 was discontinued – this is the last one! 

Additional information

Weight 0,752 kg

Other products that might interest you

Special category of products